How To Handle Laser Cutting Machine Collision And Overload?

How to handle laser cutting machine collision and overload?
1. Can the laser head be restricted from colliding with the machine?
The origin switch is broken or not set on the panel.
2. Cutting without sealing?
Belt adjustment and parameter settings.
3. Is the laser cutting machine connected to the machine pre tuned for light processing without light?
It's a control card issue
4. Inconsistent cutting size?
Wheelbase and pulse not adjusted properly
5. When working, does a complete curve have a small distance that jumps over without cutting, also known as bouncing light?
It is caused by the looseness of the sliding blocks on both sides of the cart during long-term high-speed operation, which can be solved by readjusting the sliding blocks on both sides of the cart.
6. When working, some parts of the same board are cut continuously, and some parts are cut off?
If it is caused by light deviation or uneven working surface, it is necessary to adjust the light and level the working surface. Sometimes the light deviation is caused by deformation of the guide rail, and at this point, it is necessary to adjust the guide rail.
7. When cutting with a laser cutting machine, sometimes the two ends are cut into each other or sometimes separated?
If the fixing screws of the synchronous wheel are loose or there is a problem with the motor wire, replace all of them as a group, and do not replace one or two separately.
8. Is the chiller prone to high temperature alarms in summer?
The weather is too hot, and the chiller has poor heat dissipation or insufficient cooling capacity. Homemade chillers do not have the problem of insufficient cooling capacity. Generally, the problem is that the cooling fins are too dirty and the ventilation is poor, leading to an alarm. Small chillers usually have insufficient cooling capacity, so the temperature difference can be increased and the alarm temperature can be appropriately raised to solve the problem.
9. When there is light, there is no light?
First, the signal temperature is unstable, including the light output signal and the water chiller signal, then check whether the potentiometer has poor contact, and then check whether the power supply is broken.
10. Can't the startup car move if it doesn't return to its original position?
It's all because the car motor is not powered on, and the laser head can be easily pushed by hand when turned on. The cause of the malfunction is that the 48V switch power supply is broken or self protective. It can be turned off for ten minutes before turning on, and if it's not ready, replace it with a 48V switch power supply.
11. Cut a few minutes and the light from the laser tube becomes very weak?
There are three possibilities: there is a power problem, the laser tube is broken, and the output frequency of the laser tube in the software is incorrect.
12. Does the cart often shake violently when moving?
If there is a problem with the servo limit line or limit, changing the line or limit can solve it.